Epiphan VGA Printer User Manual download pdf (Page 43)

4. VGA Printer Web admin interface Configuring the Ethernet Bridge For Use if You Have Only

User Guide Page 43

3 Log into the Web admin interface.

If you have been able to assign the VGA Printer an IP address

steps:

• Change the IP address of the PC connected to ETH 1 to:

IP Address: 192.168.255.249

Subnet Mask: 255.255.255.252

Follow the instructions for your operating system. If your

operating system supports adding more than one IP

address, then you can add this IP address as a second IP

address instead of changing the current address.

• Start a web browser on the PC and browse to:

http://192.168.255.250

• Enter the following:

User Name: admin

Password: (no password required)

• Press Enter to log into the Web admin interface.

4 In the Ethernet Bridge section, select Enable.

5 Select Change Ethernet Bridge Configuration.

6 Select Continue.

7 Scroll down the Web admin interface to the Reboot the

system section and select Reboot. Then select Continue.

It takes a few minutes for the device to reboot.

8 Scroll down to Change IP Address.

9 Set How to obtain IP address to Use static address.

10 Enter the following network settings:

IP: 192.168.10.101

Mask: 255.255.255.0

Gateway: 192.168.10.200

DNS server: (leave blank)

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 85 86

No comments

Epiphan VGA Printer User Manual Page 43