Epiphan VGA Printer User Manual download pdf (Page 41)

4. VGA Printer Web admin interface Configuring the Ethernet Bridge For Use if You Have Only

User Guide Page 41

5 Scroll down the Web admin interface to the Reboot the

system section and select Reboot. Then select Continue.

It takes a few minutes for the device to reboot.

6 Connect ETH 1 directly to the PC using a cross-over or regular

Ethernet cable.

7 Connect ETH 2 to the network.

Figure 20:Connecting a network and a PC to the VGA Printer

device

Connecting a Network Printer Directly to the

VGA Printer ETH 2 Port

You can use the following procedure to connect a supported

network printer directly to a VGA Printer Ethernet port. Usually

you would connect the printer to the ETH 2 port and keep the

ETH 1 port available for connecting a PC or for connecting the

VGA Printer device to a network.

VGA

Cable

ETH 1

ETH 2

VGA source

Ethernet

Network

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 85 86

No comments

Epiphan VGA Printer User Manual Page 41